Toparc 057678 Instructions D'utilisation page 4

DESCRIPTION OF HOT AIR GUN
1- Power cord
2- On/Off Switch
3- Thermostat
4- Ergonomic handle
5- Air filter (cleaning brush provided)
6- Rubber protection
7- Hot air nozzle
8- Protection tube
9- TIP - Nozzle
10- Fixing screw
INSTRUCTIONS OF USE
• Use the adapted nozzle and plug the hot air gun.
• Adjust the temperature using the thermostat, switch on the hot air gun and wait until the gun reaches the desired
temperature (+/- 5 min).
• IT IS MANDATORY to let the gun cool down after use (thermostat on position 0).
• After use, let the hot air gun on, on thermostat position 0, to let it cool down before switching OFF. Failure to do so
may lead to irreversible damage to the hot air gun.
• Do not touch the hot air nozzle. Regularly clean the air filter using the provided cleaning brush.
AUTOMOTIVE PLASTICS REPAIR
• Fit the TIP20MM nozzle on the hot air gun.
• Let the hot air gun heat up, on thermostat position 8.
• On the front side of the bumper, make a chamfer on the crack and glue an aluminium tape on the back side.
• Heat up the plastics brazing stick before applying it on the bumper.
• Continue heating the brazing stick, while slowly applying it on the bumper.
• Let the repair area cool down, or use a Freezer spray can to cool down faster.
• Grind using an orbital sander (low speed), then apply putty, primer and paint.
• In case of large cracks or holes, apply a stainless steel mesh on the back side.
TECHNICAL DATA
Power :
Voltage :
Frequency :
Temperature :
Air Flow :
Weight :
Dimensions :
Conformity :
4
PLASTICS WELDING KIT
1600 W
230 V ̴
50/60 Hz
20 – 700 °C
max.230 l/min
1.3 kg avec Cordon 3 M
Ø 100 x 300 mm handle Ø 56 mm
CE
EN