MV Agusta F4 750 SR Livret D'utilisation Et D'entretien page 177

Table des Matières

Publicité

SCHEMA MONTAGGIO CAVI BATTERIA - BATTERY SCHEME - SCHÉMA BATTERIE - SCHALTPLAN BATTERIE - ESQUEMA MONTAJE CABLES BATERIA
Posizionamento e montaggio dei terminali (capicorda) sulla batteria.
I
-
Montare i 2 terminali positivi (+) sul relativo polo della batteria rispettando l'ordine indicato in Fig. A
e in Fig. B. Stringere la vite utilizzando una coppia di serraggio pari a 7÷8 Nm.
-
A montaggio avvenuto sistemare la cuffia di protezione sul polo positivo (Fig. C).
-
Montare i 2 terminali negativi (-) sul relativo polo della batteria (Fig. D). Stringere la vite utilizzando
una coppia di serraggio pari a 7÷8 Nm.
ATTENZIONE: Assicurarsi che il cavo superiore del terminale positivo sia posizionato
all'interno della struttura del telaietto posteriore (Vedi Fig. D).
-
I cavi di collegamento alla batteria devono passare al di sotto del supporto rotazione sella.
Terminals (wire terminals) positioning and fitting on the battery.
GB
-
Fit the 2 positive terminals (+) on the relevant battery pole, as shown in Fig. A and Fig. B. Tighten
the screw at torque 7÷8 Nm.
-
Afterwards, fit the cap on the positive pole (Fig. C).
-
Fit the 2 negative terminals (-) on the relevant battery pole (Fig. D). Tighten the screw at torque 7÷8 Nm.
WARNING: Make sure that the upper wire of the positive terminal is placed within the rear
frame (See Fig. D).
-
The battery connection cables must pass under the saddle rotation support.
F
Positionnement et montage des terminaux (cosses) sur la batterie.
-
Monter les deux terminaux positifs (+) sur le pôle correspondant de la batterie en respectant l'ordre
indiqué dans les Fig. A et Fig. B. Serrer la vis en utilisant un couple de serrage égal à 7÷8 Nm.
-
Au terme du montage, placer la calotte de protection sur le pôle positif (Fig. C).
-
Monter les deux terminaux négatifs (-) sur le pôle correspondant de la batterie (Fig. D). Serrer la vis
en utilisant un couple de serrage égal à 7÷8 Nm.
ATTENTION: Veiller à ce que le câble supérieur de la borne du positif soit positionné à
l'intérieur de la structure du cadre arrière (voir Fig. D).
-
Les câbles de connexion à la batterie doivent passer sous le support de rotation de la selle.
D
Anbringung und Montage der Kabelanschlüsse an der Batterie
-
Die beiden Kabelenden (+) am Pluspol der Batterie anbringen, dabei die in Fig. A und Fig. B gezeig-
te Reihenfolge einhalten. Die Schraube mit einem Drehmoment von 7 ÷ 8 Nm festziehen.
-
Nach der Montage die Schutzkappe über den Pluspol ziehen (Fig. C).
-
Die beiden Kabelanschlüsse (-) am Minuspol der Batterie anbringen (Fig. D). Die Schraube mit
einem Drehmoment von 7 ÷ 8 Nm festziehen.
ACHTUNG: Sicherstellen, dass das obere Kabel zum Pluspol der Batterie innerhalb der
Struktur des hinteren kleinen Rahmens angebracht wird (siehe Fig. D).
-
Die Batteriekabel müssen unter dem Sattel-Drehpunkt durchgeführt werden.
Colocación y montaje de los terminales (terminales de cable) en la batería.
E
-
Montar los dos terminales positivos (+) sobre el correspondiente polo de la batería respetando el orden
indicado en la Fig. A y en la Fig. B. Apretar el tornillo utilizando un par de apriete igual a 7÷8 Nm.
-
Una vez finalizado el montaje colocar el capuchón de protección sobre el polo positivo (Fig. C).
-
Montar los dos terminales negativos (-) sobre el correspondiente polo de la batería (Fig. D). Apretar
el tornillo utilizando un par de apriete igual a 7÷8 Nm.
PELIGRO: Asegurarse que el cable superior del terminal positivo se encuentre en el inte-
rior de la estructura del chasis trasero (Ver Fig. D).
-
Los cables de conexión a la batería deben pasar por debajo del soporte rotación sillín.
CUFFIA DI PROTEZIONE
CALOTTE DE PROTECTION
FIG. A
CAPUCHÓN DE PROTECCIÓN
SUPPORTO ROTAZIONE SELLA
SADDLE ROTATION SUPPORT
SUPPORT DE ROTATION DE LA SELLE
SATTEL-DREHPUNKT
SOPORTE ROTACIÓN SILLÍN
Part. N. 8000A3103 Revisione 1
GUAINA ROSSA ( + )
RED SHEATING ( + )
GAINE ROUGE ( + )
HÜLLE ROT ( + )
VAINA ROJA ( + )
FIG. C
CAP
SCHUTZKAPPE
GUAINA NERA ( - )
BLACK SHEATING ( - )
GAINE NOIRE ( - )
HÜLLE SCHWARZ ( - )
VAINA NEGRA ( - )
FIG. D
FIG. B

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

F4 750 sr 1+1

Table des Matières