Section 4 Operation; Esp-101 Controls - ESAB ESP-101 Manuel D'instruction

SECTIoN 4
DaNgEr
WarNINg
CauTIoN

4.1 ESP-101 Controls

a. Power Switch (oN-off)/(I-o). Turn knob clockwise to "ON" ("I") position for normal operation. Turn knob counter-
clockwise to switch "OFF" ("O").
Note that with the switch in the "ON" ("I") position, power is provided to the main transformer and the low voltage
control circuitry. In the "OFF" ("O") position, the unit is shut down; however, power is still present in the unit. To remove
power from the power source, power must be disconnected at the line disconnect switch or the fuse box.
B. Pressure regulator. Regulates cut gas pressure. Rotate clockwise to increase and counterclockwise to decrease. Pressure
reading is indicated on the lower display screen. Pressure unit of measure is indicated on the upper display screen.
With or without Junction Box installed: When using 4.5' (1.4 m) or 17' (5.2 m) torch assemblies, plasma gas settings
The unit is shipped from the factory with the regulator adjusted to deliver 80 psig (5.5 bar) to the torch from a 95 psig
(6.5 bar) supply. If supply pressure to the machine is greater than 95 psig (6.5 bar) up to the maximum recommended
150 psig (10.3 bar), rotate pressure regulator knob counterclockwise to reduce the pressure delivered to the torch
A
ElECTrIC ShoCK CaN KIll.
• Do NoT operate the unit with the cover removed.
• Do NoT apply power to the unit while holding or carrying the unit.
• Do NoT touch any torch parts forward of the torch handle (nozzle, heat shield, elec-
trode, etc.) with power switch on.
arC raYS CaN BurN EYES aND SKIN; NoISE CaN DaMagE hEarINg.
• Wear welding helmet with No. 6 or 7 lens shade.
• Wear eye, ear, and body protection.
Position the ESP-101 at least 10 feet (3 meters) from the cutting area.
Sparks and hot slag from the cutting operation can damage the
unit.
should be reduced 5 - 10 psi (.35 - .69 bar) for optimum performance.
back to 80 psig (5.5 bar). Follow GAS TEST instructions, see D.2.
figure 4-1. ESP-101 Controls
Note:
Note:
B
31
oPEraTIoN