Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
1. OPERATORS AND OTHERS IN WORK AREA MUST WEAR SAFETY GLASSES WITH SIDE
SHIELDS.
2. NEVER USE OXYGEN OR OTHER BOTTLED GASES. EXPLOSION MAY OCCUR.
3. NEVER POINT TOOL AT YOURSELF OR OTHERS IN WORK AREA.
4. KEEP FINGERS AWAY FROM TRIGGER WHEN NOT DRIVING FASTENERS TO AVOID
ACCIDENTAL FIRING.
Never carry the Nailer with finger on trigger since you could drive a fastener
unintentionally and injure yourself or someone else.
Always carry the Nailer by the handle only.
5. CHOICE OF TRIGGERING METHOD IS IMPORTANT.
Read and understand section titled "METHODS OF OPERATION" (pages 19 – 21).
6. DO NOT EXCEED 120 psi. (8.3 bar 8.5 kgf/cm
4
SAFETY
IMPORTANT SAFETY INSTRUCTIONS
FOR USING NAILERS
READ ALL INSTRUCTIONS
When operating the Nailer, always wear safety glasses with side
shields, and make sure others in work area wear safety glasses, too.
Safety glasses must conform to the requirements of American
National Standards Institute, ANSI Z87.1 and provide protection
against flying particles both from the front and side.
The employer must enforce the use of safety glasses by the Nailer
operator and others in work area.
Never use oxygen, combustible gases or any other bottled gases as
a power source for the Nailer.
Use of the above gases is dangerous, as the Nailer will explode.
Use only clean, dry, regulated compressed air.
Always assume the Nailer contains fasteners.
Never point the Nailer at yourself toward yourself or others, whether
it contains fasteners or not.
If fasteners are mistakenly driven, it can lead to severe injuries.
Never engage in horseplay with the Nailer.
Respect the Nailer as a working implement.
Do not exceed maximum recommended air pressure
120 psi (8.3 bar 8.5 kgf/cm
Never connect the Nailer to pressure which potentially
exceeds 200 psi (13.7 bar 14 kgf/cm
burst.
DANGER
WARNING
2
)
2
).
2
) as the Nailer can
Publicité
Table des Matières
