AQUA FORTE ZWPA Serie Manuel D'installation Et D'utilisation page 3

Dear customers, please read this instruction carefully before the installation and applicationof this
product, otherwise it may lead to damage to the instrument or operators as well asfinancial loss. When
you might need further information please contact your local distributor. With the gradual advancement
of science and technology, the product series and specifications will change as well, so you are invited to
keep up with the latest products. In reading this instruction, if you need any technical consultations,
contact your local distributor.
ATTENTION:
√ In selecting the heat pump water heater unit to install, check whether the corresponding power
supply agrees with the specifications for heat pump water heater unit power, For detail, refer to the
tag on the unit or the installation and operation instruction.
√ Make sure electricity leakage protection equipment is installed properly according to the
regulations and guidelines valid in your area. If you're not sure please contact a professional
electrician.
√ The water heater unit must be reliably ground. It is forbidden to use this unit with no reliable
grounding. It is forbidden to connect the ground wire to the zeroline or running water pipes.
√ In wire connection, the electrician must refer to the connection map and wiring diagrams, which can
be found in the back of this manual.
√ For safety, do not change or repair the heat pump water heater unit without permission. If
necessary to make any adjustments you should always contact your local distributor before
adjustment.
√ It is forbidden to insert any tools into the heat pump unit in case it may touch the fan to damage the
unit or lead to accidents (especially for children).
√ Hot water with a temperature of more than 52℃ can lead to burns. Therefore, only when the hot
water in water tank combines with cold water can it be used.
√ Do not use the water heater unit with the grid or plate work removed in case it may lead to any
accidents or abnormal operation of the unit.
√ If the unit is soaked by water, contact immediately with our factory or its service department. The
unit can be reused only after check and solution by the technical staff.
√ Unqualified technical staff are not allowed to adjust the switches, valves or controllers in the unit.
ZWEMBAD WARMTEPOMP