Setting The Time; Parameter Table - AQUA FORTE ZWPA Serie Manuel D'installation Et D'utilisation

4.4 Adjust desired water temperature
1. First select the desired mode; auto, heating or cooling.
2.
Then use the arrow buttons to increase or decrease the set value. The LED display will show the set value.
4.5 How to check and set the parameters
1. Press "MENU" button for 5 seconds. The Parameter number and value will start flashing together on the LED
display.
2. Use the arrow buttons to navigate to the required parameter number.
3. Press the "MENU" button to choose the required parameter. The parameter number stays fixed, while the
value will continue to flash.
4.
Use the arrow buttons to set the desired value for the chosen parameter. You can press the MENU button to
confirm the settings. Without any further movement on the display buttons in 5 seconds i twill return to the
main interface automatically.
ATTENTION!
You can always enter the parameter list and check the values, but the set values can only be changed when the heat
pump is in standby status.

4.6 Setting the time

1. Press MENU button in a quick stop to activate time setting
2. The hour numbers start flashing, adjust them with the arrow buttons
3. Press MENU button to confirm the hour setting
4. The minute numbers start flashing, adjust them by using the arrow buttons
5. Press MENU button to confirm the minutes setting
6. The LED display will return to the main interface

4.7 Parameter Table

Parameter
Desired water temperature in
0
cooling mode
Desired water temperature in
1
heating mode
Omschrijving Range Default
8 – 37 °C 28 °C
5 – 40 °C 28 °C
Remark
End User
(page. 20)
End User
(page. 20)