LENCO TCD-973 Mode D'emploi page 5

Lecteur cd/mp3 avec platine stereo, radio et encodeur usb/sd
Table des Matières

Publicité

PLAYBACK OF MP3/WMA SONG VIA USB STORAGE MEDIA OR MEMORY CARD
CONNECTING
THE SYSTEM IS ABLE TO DECODE AND PLAYBACK ALL MP3 /WMA FILE WHICH STORED IN THE MEMORY
MEDIA WITH USB CONNECTING PORT OR SD/MMC MEMORY CARD.
1.
SET FUNCTION SELECTOR (15) AT CD/USB MODE AND THEN PRESS SOURCE BUTTON (6) TO SELECT
" USB OR CARD" MODE.
2.
PLUG-IN THE USB PLUG WITH THE FACE UP & MAKE SURE IT
GOING INTO COMPLETELY OR INSERT THE MEMORY CARD IN
THE DIRECTION OF THE ARROW AS SHOWN IN THE LABEL ON
THE UNDERSIDE OF THE MEMORY CARD SLOT COVER. INSERT
STRAIGHT WITHOUT BENDING.
CONNECTING THE USB UPSIDE DOWN OR BACKWARDS COULD
DAMAGE THE AUDIO SYSTEM OR THE STORAGE MEDIA (USB
THUMB DRIVE / SD/MMC CARD). CHECK TO BE SURE THE
DIRECTION IS CORRECT BEFORE CONNECTION.
3.
THE SYSTEM WILL START READING THE STORAGE MEDIA
AUTOMATICALLY AFTER CONNECTING, AND LCD DISPLAY (18)
WILL SHOW THE TOTAL NUMBER OF MP3/WMA FILES AND TOTAL
NUMBER OF FOLDER BEING DETECTED.
4.
REPEAT THE SAME PLAYBACK PROCEDURE AS PLAYING CD/MP3
DISC AS ABOVE
REMARK
-
THE SYSTEM CAN DETECT AND READ THE FILE UNDER MP3 AND WMA FORMAT ONLY THOUGH THE
USB PORT.
IF CONNECT THE SYSTEM TO MP3 PLAYER VIA THE USB SOCKET, DUE TO VARIANCES IN MP3
-
ENCODING FORMAT, SOME MP3 PLAYER MAY NOT BE ABLE TO PLAY VIA THE USB SOCKET. THIS IS
NOT A MALFUNCTION OF THE SYSTEM.
ENCODING OF CD/PHONO INTO MP3 FILE
THE SYSTEM IS ABLE TO ENCODE NORMAL CD OR TURNTABLE TO MP3 FORMAT AND RECORDING AT
MEMORY MEDIA WITH USB CONNECTING PORT.
A) CD ENCODING
I) ECNODING 1 TRACK
1.
PERFORM NORMAL PLAYBACK OF THE CD TRACK YOU WANT TO ENCODE & RECORD,
2.
PRESS " RECORD " BUTTON (9) DURING THE PLAYBACK OF THE DESIRE TRACK, UNIT WILL DISPLAY
"
" & "
3.
AFTER COMPLETING OF ENCODING, UNIT WILL STOP PLAYBACK AUTOMATICALLY.
II) ENCODING 1 DISC
1.
PLACE A CD WITH THE PRINTED SIDE FACING UP INSIDE THE TRAY & THEN CLOSE THE CO DOOR
2.
PRESS THE " RECORD " BUTTON (9) AFTER FOCUS SEARCH COMPLETED. UNIT WILL DISPLAY "
" & "
" AND FLASHING. ENCODING IS PERFORMING NOW.
3.
AFTER COMPLETING OF ENCODING, UNIT WILL STOP PLAYBACK AUTOMATICALLY.
REMARK:-
-
THE RECORDING SPEED IS 1:1 AND ACCORDING TO THE ACTUAL PLYING TIME OF THE CD TRACK
-
THE SYSTEM WILL CREAT A " AUDIO " FOLDER AND THEN STORE THE ENCODING TRACK IN IT.
-
THE RECORDING FORMAT IS PRESET AT – MP3
-
NO SONG TITLE WILL BE RECORDED DURING ENCODING MODE
-
TO INTERRUPT THE RECRODING, PRESS THE " RECORD " BUTTON AGAIN DURING RECORD MODE.
RECORDING WILL BE COMPLETED ONLY ENTIRE SONG BEING ENCODED, IF TERMINATE THE
-
ENCODING PROCESS INTERMEDIATELY, THERE IS NO TRACK BEING RECORDED NOR STORED TO
THE USB OR SD/MMC CARD
III) COPYING OF MP3/WMA FILE
IF PUTTING A MP3/WMA DISC INSTEAD OF A CD-DISC, THE SYSTEM WILL COPY THE FILES TO THE USB OR
SD/MMC CARD IF PRESS THE " RECORD " BUTTON (9). THE OPERATION PROCEDURES IS SAME AS CD
ENCODING AS STIPULATE ON ABOVE, AND THE SYSTEM WILL SWITCH TO COPYING MODE ONLY IF
MP3/WMA FILE BEING READ.
REMARK:
-
THE SYSTEM WILL STORE THE FILE TO USB SORCE FIRST IF BOTH USB AND SD SLOT ARE BEING
OCCUPLIED BY STORAGE MEDIA.
-
IF PRESS THE " RECORD " BUTTON DURING PLAYBACK OF USB OR SD SOURCE, THE FILE WILL COPY
FROM USB TO SD OR SD TO USB.
" AND FLASHING. ENCODING IS PERFORMING NOW.
BIT RATE : 128 KBPS, SAMPLING RATE : 44.1KHZ
GB-4

Publicité

Table des Matières
loading

Table des Matières