Abus AZWG10100 Mode D'emploi page 5

Recording
1. On the voice module, plug the jumper on the two pins of the REC position
(h).
2. Press and hold down one of buttons 1-4 (a-d) and record your message.
Make sure that the PLAY/REC LED (i) is on. You get best results with a
distance of about 20 cm from the microphone (e).
3. To end recording, release the pressed button. When the recording time
expires, recording is automatically stopped.
4. Repeat steps 1-3 to record the other voice messages.
Playback
1. On the voice module, plug the jumper on the pin of the PLAY position (g).
2. Now plug the jumper supplied with the two connecting leads (black/red) on
to the J12 pin (f).
3. Connect an 8 Ohm loudspeaker (not supplied) to the two leads.
4. Now press one of the buttons 1-4 and listen to the recorded voice
message.
5. To end playback, release the pressed button, and the PLAY/REC LED
switches off.
6. Repeat steps 1-3 to hear the other voice messages.
© Security-Center GmbH & Co. KG, April 2011
5
AZWG10100