Human Touch Novo XT Manuel D'utilisation Et D'entretien page 4

get ready
Unpack the box
Power cord
Choose a location
When deciding where to place your Novo XT, consider the following:
• Place the unit on a flat surface, away from direct sunlight or any other direct heat source (to avoid fading).
• If you wish to place the unit on a hard surface, it is recommended that you place a piece of carpet or a soft mat
underneath it to avoid damaging the floor (minimum 48" x 28").
• To accommodate the footrest when deployed, make sure the area in front of the chair is clear for at least 32".
humantouch.com
Remote Control Softening Soles
Chair
Clearance
32"
4
Assembling your massage chair is easy!
cord and the remote control, and you're set to go!
Move the chair to the desired location
CAUTION: To avoid injury to yourself and damage to the product, have two or more people move the chair.
1. Using two people, push down on the backrest and lift up on the front sides. WARNING: Do not lift the chair by the footrest.
Never manually lift the footrest.
2. Roll the chair on its casters to the desired location.
3. Gently lower the chair all the way to the floor: WARNING: Dropping the front of the chair to the floor may damage
the chair and/or floor.
X
Caster
Attach the remote control and power cord
1. Plug the power cord into the receptacle on the back rear of the chair.
2. Plug the remote control cord into the receptacle on the inside of the right side of the chair, near the seat.
3. Turn the metal ring surrounding the remote control connector clockwise to secure it.
Remote control cord
Simply plug in the power
WARNING:
DO NOT LIFT
THE CHAIR BY THE FOOTREST
Power cord
Back of chair
5