Preparations: Charging And Notes - Carson Mini Tyrann 50 050 7037 Mode D'emploi

i. Preparations: Charging and Notes
Notes on the charger
Information:
Output voltage: DC 4.2 V
Charging current: 650 mA
Display status:
Green LED: Charging finished or no battery connected
Red LED: Charging
Automatic charging cut-off:
If the voltage of the battery being charged reaches 4.2 V, battery char-
ging stops automatically.
Instructions for use:
1. Plug the charger into the mains socket (Note: the voltage must be
compatible with the charger. The supply voltage differs in various
countries.)
Now the status LED glows green, indicating that the charger is
working normally and is ready to charge.
2. Connect the battery to the charger ensuring correct polarity. The
LED now glows red, indicating that the battery is being charged.
3. If the LED flashes, the charger is entering the "charging current
reduction" phase. After the charging process is finished, the LED
turns green and the battery is fully charged and ready to use.
Install flight battery
Please insert the battery in the battery holder from the rear, cautiously.
Warning
1. Under no circumstances should the charger casing be opened nor
any alterations made.
2. During the charging process, please ensure that you do not position
the charger in the vicinity of flammable materials.
3. The charger must only be used for the original flight battery.
4. During charging the charger must be kept out of the reach of
children.
5. Never leave the charger unattended during use.
6. If the LEDs on the charger go out, the temperature of the battery or
power supply unit suddenly increase etc., stop the charging process
immediately and unplug the unit from the power supply.
7. After use and before subsequent charging, the flight battery must
be allowed to cool completely.
CARSON Mini Tyrann
GB
33