Lipo Battery Charging - Carson EASY TYRANN 180 Mode D'emploi

LIPO BATTERY CHARGING

The helicopter is fitted with a LiPo battery.
3.7 V LiPo battery.
The supplied LiPo battery is stored in the body of the helicopter.
Charging via the radio control unit:
- Switch the radio control unit ON
- Switch the helicopter OFF
- Connect the USB charging cable between the radio control
unit and the helicopter
- Power LED on the USB charger goes out: charging battery
- LED glows: battery is charged
Charging from a computer USB connection:
- Switch the helicopter OFF
- Connect the USB charging cable between the computer and
the helicopter
- Power LED on the USB charger goes out: charging battery
- LED glows: battery is charged
GET THE HELICOPTER READY FOR TAKEOFF
Now we're good to go! But before liftoff, make sure that you have read this manual through completely.
ON/OFF
switch
1
Connect the battery to the helicopter. Switch the helicopter on and
place it on a level surface.
3
Now move the throttle lever completely up and then back down.
Now the helicopter is ready to launch.
1
1
2
Now push the throttle lever fully down and then switch on the
transmitter.
2
2
ON/
OFF
17 // GB