Cleaning The Air Filter; Replacing The Belt - Husky C801H Guide D'utilisation Et D'entretien

Maintenance (continued)

CLEANING THE AIR FILTER

From time to time, the air filter needs to be removed
and cleaned.
□
Turn the air compressor OFF ( O ).
□
Unplug the air compressor.
□
Remove the wing nut
□
Remove the outer metal cover (1)
□
Remove the air filter element (2) from the air
filter housing (3).
□
Blow compressed air through the air filter
element for 10-15 seconds.
□
If the air filter element is filled with paint or
needs replacing, then replace.
□
Replace air filter element into housing.
□
Place the outer metal cover back over the filter
element.
□
Secure the wing nut.

REPLACING THE BELT

WARNING: Serious injury or damage may occur if parts
of the body or loose items get caught in moving parts.
Never operate the outfit with the belt guard removed.
The belt guard should be removed only when the air
compressor power is disconnected.
□
Turn the air compressor off, lock out the power
supply, and relieve all air pressure from the air
tank.
□
Remove the fasteners from the front belt guard.
The front belt guard can now be lifted up and
away from the unit.
□
Mark the motor position on the saddle.
□
Loosen the motor mounting screws and slide the
motor toward the air compressor pump.
□
Remove the belt and replace with a new one.
□
See Adjusting the Belt Tension before tightening
the motor mounting screws.
3
2
20
1