turck TS400/500 Série Mode D'emploi page 41

12 Typical curves of the analogue outputs
Current output
4...20 mA
I [ mA ]
20
4
–50 0 ASP
Within the defi ned measuring range between ASP (analogue start point)
and AEP (analogue end point), the output signal is between 4 and
20 mA or alternatively between 0 and 20 mA. The factory-set measuring
range is between 0 and MEW (measuring range end value) and the de-
fault output signal is between 4 mA (ASP) and 20 mA (AEP).
Voltage output
0...5 V or 0...10 V
U [ V ]
5 bzw.10
0 ASP
–50
Within the defi ned measuring range between ASP (analogue start point)
and AEP (analogue end point), the output signal is between 0 and 10 V or
alternatively between 0 and 5 or 1...6 V. The factory-set measuring range
is between 0 and MEW (measuring range end value) and the default out-
put signal is between 0 V (ASP) and 10 V (AEP).
Hans Turck GmbH & Co.KG • D–45466 Mülheim an der Ruhr • www.turck.com
AEP MEW T
AEP MEW T
0...20 mA
I [ mA ]
20
0 ASP AEP
–50
1...6 V
U [ V ]
6
1
–50 0 ASP AEP
MEW T
MEW T
17
/0208