Installation And Set-Up Instructions; Mounting - turck TS400/500 Série Mode D'emploi

4 Installation and set-up instructions

1. Even though the device is excellently protected against electro-
magnetic interference, installation and cabling must be carried out
correctly to ensure interference immunity.
2. Never route signal and control cables together with the mains cable
or feeder cables of motors, cylinder coils, rectifi ers etc. The cables
must be routed in conductive and grounded cable conduits. This
applies especially to long-distance cables, or environments in which
the cables are exposed to strong radio waves from broadcasting
stations.
3. Signal lines should be installed in mounting cabinets and as far
away as possible from contactors, control relays, transformers and
other sources of interference.

5 Mounting

• Signifi cant thermal changes in the environment of the processor unit
can lead to a measured value offset. This kind of drift can be
corrected (see chapter 10.2, parameter CoF).
• The read direction of the on-site display can be rotated via
software by 180° (see chapter 10.2, parameter diS).
• In the pressureless state, the housing of the TS500... series can be
rotated by 340° after mounting.
Hans Turck GmbH & Co.KG • D–45466 Mülheim an der Ruhr • www.turck.com
!
5
/0208