Technical Data; Specified Conditions Of Use; Residual Risk; Emergency Procedure - Güde GSH 180-TC-2 Traduction Du Mode D'emploi D'origine

Technical Data

Automatic welding helmet
Art. No
Type of electricity supply
Protective glass
Protective glass, Dimensions L x W x H
Visual field L x W
Response time light/dark
Response time dark/light
Darkness value
Lightness value
Recommended Ambient Operating Temperature
Dimensions L x W x H
Net/gross weight
Read and understand the operating
instructions before using the
appliance. Familiarise with the
control elements and how to use the appliance
properly. Abide by all the safety measures stated in
the service manual. Act responsibly toward third
parties.
The operator is responsible for accidents or risks to
third parties.
In case of any doubts about connection and operati-
on refer please to our customer center

Specified Conditions of Use

This welding helmet protects the eyes and face
against sparks, splashes and UV radiation during
welding and adjusts automatically to the light
conditions. It ensures immediate, sensor-controlled
darkening in the event of ignition of the arc and
automatic lightening again once the welding process
has finished (including short delay to protect against
any afterglow).
The welding helmet has a fully-adjustable DIN pro-
tection level with adjusting wheel to the side.
The welding helmet can also be adjusted for flying
sparks with welding and cutting work.
The filter response time slows if the temperature
exceeds or falls below that specified.
Please note that our equipment has not been desi-
gned for commercial, craft or industrial use. If the
equipment is used in commercial, craft or industrial
operation or for similar activities, we cannot assume
any liability.
Do not use this product in any other way as stated
for normal use. Not observing general regulations
in force and instructions from this manual does not
make the manufacturer liable for damages.
Always pass on the device to third parties toge-
ther with these operating instructions.
Requirements for operating staff
The operating staff must carefully read the Opera-
ting Instructions before using the appliance.
Since the use of the device if handled incorrectly
can entail considerable risks, only knowledgeable
persons may be entrusted with the use of it.
The operator must be appropriately trained in set-
ting up, operating and using the machine.
Qualification: Apart from the detailed instructions
by a professional, no special qualification is necessa-
ry for appliance using.
Minimum age: Persons over 18 years of age can
only work on the appliance. An exception includes
youngsters trained in order to reach knowledge
under supervision of the trainer during occupational
education.
Training: Using the appliance only requires corres-
ponding training by a professional or the Operating
Instructions. No special training is necessary. The
operator is responsible for accidents or risks to third
parties.

Residual Risk

Despite the observance of the operating instructions
there still may be some hidden residual risks.

Emergency procedure

Conduct a first-aid procedure adequate to the injury
and summon qualified medical attendance as quickly
as possible. Protect the injured person from further
harm and calm them down.
ENGLISH
GSH 180-TC-2
16924
Li - CR 2450
379 DIN
133 x 114 x 10 mm
100 x 83 mm
0,1 ms
100 - 800 ms
DIN 5-9/9-13
DIN 4
-5 °C - 40 °C
323 x 238 x 238 mm
0,6 kg / 0,9 kg
27