Stitch Selector Dial - Singer 44S Mode D'emploi

a. Reverse Sewing Lever
b. Needle Position Dial
c. Stitch Width Dial
d. Stitch Length Dial
e. Stitch Selector Dial
The Stitch Selector Dial is used to select the stitch you want to sew. The dial can be turned to the left
or to the right.
For Sewing the Black Stitch Patterns:
Needle Position Dial
Stitch Width Dial Stitch Length Dial
For Sewing the Blue Stitch Patterns:
S
1
Needle Position Dial
Stitch Width Dial Stitch Length Dial
For examples of stitch patterns and further instruction, see the Stitch Reference Guide at www.
singerco.com.
START SEWING

Stitch Selector Dial

a b c
1. Turn the Stitch Selector Dial until it clicks in
place under the dot directly above the dial
on the machine.
2. Set the Needle Position Dial so that the
center position is located directly in front
the dot on the top cover of the machine.
3. Set the Stitch Width Dial to a wide setting
(4-6). If desired, you can set it to a lower
setting, depending on the look you want.
4. Set the Stitch Length Dial according to the
length you want. It can be set anywhere
between 0.5 and 4, with 4 being the longest
setting.
1. Turn the Stitch Selector Dial until it clicks in
place under the dot directly above the dial
on the machine.
2. Set the Needle Position Dial so that the
center position is located directly in front of
the dot on the top cover of the machine.
3. Set the Stitch Width Dial to a wide setting
(4-6). If desired, you can set it to a lower
setting, depending on the look you want.
4. Set the Stitch Length Dial so that the S1 is
lined up with the dot above this dial. This
dial must be set at the S1 marking, or the
stitch pattern will not sew.
d
e
3
of
19