Automatic Needle Threader - Singer 44S Mode D'emploi

⚠
For safety, turn off the power before using the automatic needle threader.
A
C
A
Pull about 6-8" of thread to the back beyond the eye of the needle. This will help prevent the
needle from becoming unthreaded when you start to sew.
GETTING READY TO SEW

Automatic Needle Threader

1. Raise the needle to its highest position by
2. Press lever (A) as far down as it will go. Insert
3. The threader automatically swings to the
B
4. Pass the thread under thread Guide (C) from
D
5. Holding the thread gently with your right hand,
6. Pull the thread through the needle eye.
turning the handwheel toward you. If you turn
the handwheel backward, the machine will jam
when you start to sew.
the hook of the threader into the eye of the
needle by gently pushing the lever to the back.
threading position (B).
left to right and then pass the thread in front of
the needle and under the hook (D).
release the lever (A), by swinging it toward you
and back up. This will form a loop at the back of
the needle.
2
15