Dehumidification - Honeywell VisionPRO Serie Mode D'emploi

Adjusting humidification settings
1 Touch MENU and select Humidification.
2 Select Auto.
3 Touch or
s t
4 Touch Done to save your settings. Touch
Cancel
to ignore changes.
5 If frost or condensation appears on
the windows, touch MENU, then select
Window Protection. (Use a lower number
to prevent frost or condensation. Use a
higher number if indoor air is too dry.)
NOTE: Window Protection is available
only
if an outdoor air sensor is installed.
NOTE: The thermostat controls
humidification and dehumidification
as needed to maintain the desired
humidity level. Depending on how
your thermostat was installed, the
thermostat may maintain
a 15% separation between
humidification and dehumidification
settings.
Adjusting dehumidification settings: residential use
This feature can control a dehumidifier
or use your air conditioner to reduce
humidity.
1 Touch MENU and select Dehumidification.
2 Select Auto.
3 Touch or
s t
4 Touch Done to save your settings. Touch
Cancel to ignore changes.
NOTE: If your air conditioner is used
to control humidity, the temperature
may drop up to 3° F below your
temperature setting until humidity
reaches the desired level.
to select humidity level.
to select humidity level.
Window Protection
Equipment Status

Dehumidification

11
Humidification
Humidification
Off Auto
Dehumidification
Off Auto
69-2761EFS—03
MCR34100
MCR34128
MCR34129
MCR34100
MCR34130
MCR34131