Operation; Start The Engine - Briggs & Stratton 1696509 Manuel De L'opérateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operation

Add Fuel
WARNING
Fuel and its vapors are extremely flammable
and explosive. Always handle fuel with
extreme care.
Failure to observe these safety instructions can
cause a fire or explosion which will result in
severe burns or death.
When Adding Fuel
• Turn off engine and let cool at least 2 minutes before
removing the fuel cap and adding fuel.
• Fill fuel tank outdoors or in a well ventilated area.
• Do not overfill the fuel tank. To allow for the expansion of
gasoline, do not fill above the bottom of the fuel tank neck.
• Keep fuel away from sparks, open flames, pilot lights, heat,
and other ignition sources.
• If fuel spills, wait until it evaporates before starting engine.
1. Clean the fuel cap area of dirt and debris. Remove the fuel cap
(D, Figure 1).
2. Fill the fuel tank with fuel. To allow for expansion of the fuel, do
not fill above the bottom of the fuel tank neck.
3. Install the fuel cap.

Start the Engine

WARNING
Fuel and its vapors are extremely flammable
and explosive. Always handle fuel with
extreme care.
Failure to observe these safety instructions can
cause a fire or explosion which will result in
severe burns or death.
When Starting Engine
• Ensure that spark plug, muffler, fuel cap, and air cleaner (if
equipped) are in place and secured.
• Do not crank the engine with the spark plug removed.
• If fuel is spilled, do not attempt to start the engine, but move
the snowthrower away from the area of the spill, and avoid
creating any source of ignition, until the fuel vapors have
dissipated.
• Do not over-prime the engine. Follow the engine starting
instructions in this manual.
• If the engine floods, set choke (if equipped) to OPEN/RUN
position, move throttle (if equipped) to FAST position and
crank until engine starts.
10
Damaged or ungrounded power cords could
cause electric shock.
Electric shock could cause severe burns or
death.
When Using the Electric Starter
The power cord must be properly grounded at all times.
Use only a three-conductor power cord properly grounded
to the power source.
If the extension cord is damaged, it must be replaced a
qualified person to avoid a hazard.
NOTE: The electric starter is designed for a three-conductor
power cord only and operates on standard household current. If a
properly grounded electrical source is not available, DO NOT use
the electric starter. Contact a licensed electrician for installation of
a properly grounded system.
WARNING
Engines give off carbon monoxide, an
odorless, colorless, poison gas. Breathing
carbon monoxide can cause nausea, fainting,
or death.
• Start and run engine outdoors.
• Do not run the engine in an enclosed area, even if doors or
windows are open.
Rapid retraction of the starter cord (kickback)
will pull your hand and arm toward the engine
faster than you can let go.
Broken bones, fractures, bruises, or sprains
could result.
When Starting the Engine
Pull the starter cord slowly until resistance is felt and then
pull rapidly to avoid kickback.
1. Check the oil level. See Add Oil / Check Oil Level.
2. Ensure the auger control is disengaged.
3. Insert the ON/OFF key (A, Figure 2) and turn to the ON
position or insert the Push/Pull key, if equipped.
WARNING
WARNING

Publicité

Table des Matières
loading

Table des Matières