Mounting Dimensions - SIKA VM100 Notice D'utilisation

VM100
Assembly:
CAUTION! Risk of injury or material damage!
Pay attention that the housing is only hand-tightened at the works.
 Always tighten the housing after installation.

MOUNTING DIMENSIONS:

 Pay attention to the mounting dimensions in § 7.2 "Dimensions".
 Fit the flow monitor in the existing pipe in the same way as a valve.
 Pay attention to the flow arrow on the valve body. It must point in the same
direction as the flow!
The sealing on the valve body has to be carried out with either thread sealants
(Teflon tape, surface coating, etc.) or via sealing rings on the face of the tube
section.
Technical changes reserved
Installation and electrical connection
- 25 -