Service; Optional Equipment - Jotul F 400 Manuel D'installation Et Données Techniques

4.0 Service

Warning! Any unauthorised change to the product is illegal. Only
use original spare parts.
4.1 Replacing the baffle plate
1. Lift off the top plate.
2. The baffle plate rests on top of the burn plates.
3. To remove the baffle plate, loosen the brackets that push it
down against the burn plates. Use a hammer and beat them
carefully out towards the door. See fig. 5
4. Lift the baffle plate a little upwards and remove it edgeways
out through the top.
For re-installation follow the same procedure in the opposite
sequence.
4.2 Replacing the burn plates
1. The fireplace has side burn plates, which are fastened with
screws. The rear burn plate is not fastened and is kept in place
by the side burn plates.
2. When replacing remove the baffle plate first, then loosen the
screws and remove the burn plates.

5.0 Optional equipment

5.1 Short legs - height 155 mm
Black paint - cat. no. 350173
Blue-black enamel - cat. no. 350174
Ocean green enamel - cat. no. 350328
Ivory enamel - cat. no. 350176
5.2 Rear heat shield
Black paint cat no. 350694
Enamel cat. no. 350695
5.3 Connecting pipe for outdoor
ventilation - cat. no. 221031
With the aid of a connecting pipe for outdoor ventilation and a
flexible tube, combustion air can be connected to the product
directly from the outside. In this manner, the fireplace will always
be supplied with the air needed to achieve proper combustion.
Fresh air supply direct from the exterior or from the
chimney with air vents
1. Insert the connecting pipe into the air inlet under the
product.
2. Unfold the pipe"s 3 flaps (fig. 8A) inside the air inlet.
3. Attach a flexible tube (Ø 80 mm) directly to the fireplace's
connecting pipe by using a hose clamp and attach it to the
wall outlet/chimney
ENGliSh
19