INSTRUCTIONS FOR USE
This appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized
outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit.
contact a qualified electrician to install the proper outlet. DO NOT change the plug in any way.
1. Always make sure the unit is set to the "OFF" position before inserting the plug into a 120 volt
electrical outlet.
2. To turn the unit on, simply press the power
This will start the unit on the lowest setting. To increase the intensity of the massage,
continue to press the button until the desired intensity is reached. To tum the unit off,
continue to press the power
button past the highest intensity setting, which will turn
the intensity cycle and power the unit off. (figure 1)
3. To turn the HEAT
function on, the massager must be on. To activate the heat
function, press the heat
button located above the intensity bars on the top of the
handle (figure 1). To cancel the heat function, press the HEAT
NOTE: The heat function works best when the red heat node attachments are exposed.
NOTE: Do not use the heat continuously for more than 15 minutes. DO NOT use the heat if you have
sensitive skin, poor circulation, discolored areas, swelling, burned, inflamed or where skin eruptions or
sores are present. Soothing Heat should be pleasant and comfortable. Should pain or discomfort result,
discontinue use and consult your physician.
4. Apply massager head lightly to the area you wish to massage.
5. Move the unit slowly, holding on the targeted area. Massage the area for a short period of time and
move to another area. Never massage the same spot longer than 3 minutes.
CAUTION: As stated in the "IMPORTANT SAFETY INSTRUCTIONS" section of this manual, never use this
appliance on or near eyes or other highly sensitive areas.
6. Operation of longer than 15 minutes is not recommended and may cause overheating.
7. When massage is completed, turn unit off, unplug the power supply, allow to cool and store properly in
a dry place.
button located on the top of the handle.
button a second time.
Fig. 1
4
TO CHANGE ATTACHMENTS
Your massager comes with 4 custom massage head attachments.
White – soft massage
Gray – firm massage
To change to a different set, simply twist off (counterclockwise) the set that is on the unit, press in and
twist on (clockwise) the desired set.
MAINTENANCE
TO STORE
Unplug the appliance from the outlet and allow it to cool before storing in its box or a clean, dry place.
Coil the cord and secure it with the supplied fastener. Do not hang the unit by the power cord.
TO CLEAN
Clean only with a soft, damp cloth and mild cleansing agent. Never allow water or any other liquids to
come into contact with the unit.
• Do not immerse in any liquid to clean.
• Never use strong abrasives, detergents, or cleansing agents.
• Never use abrasive cleaners, brushes, gasoline, kerosene, glass or furniture polish, or paint thinner
to clean.
• DO NOT attempt to repair the Percussion Action Massager.
There are no user-serviceable parts. For service, call the Consumer Relations telephone number listed
in the Warranty Section.
5