Accessories - Storch DMS 25 PRO Mode D'emploi

Accessories

Water flowmeter
The water flowmeter is used to set the material consistency in an ideal and rational manner, guaranteeing constant
mixing results. The flow meter is fitted between the dosing valve and the mixing shaft (see figure).
1
Assembly bolt for
mounting bracket
2
Water flowmeter
3 4 5
Dosing valve Mixing pipe Water inlet
Installing the water flowmeter
Loosen the threaded joint on the water supply hose at the dosing valve (3) and uncouple the hose with the GEKA cou-
pling from the water inlet (5) on the mixing pipe (4).
Remove the nut on the assembly bolt for the mounting bracket (1) on the water flowmeter (2).
First secure the water flowmeter (2) on the dosing valve (3) with a cap nut and then on the mounting bracket and the
assembly bolt as shown above.
Align the water flowmeter (2) with the slot in the mounting bracket, and bolt down.
Connect the water supply hose to the GEKA coupling on the water inlet (5)
The water flowmeter (2) is now ready for operation.
49 Translation of the original instruction