Storch DMS 25 PRO Mode D'emploi page 47

Power supply
The DMS 25 PRO flow mixer must be connected to an approved site power distributor with residual current circuit bre-
aker or to a house mains connection with a residual current circuit breaker.
A 16 A fuse is required. When using the mixer with several units (e.g., plaster pump and compressor), it is advisable to
connect the units to different electrical circuits Use a connecting cable of 3 x 2.5 mm².
In order to prevent voltage loss and the risk of damage as a result, using a connecting cable no longer than 50 m is
recommended. Cable drums must always be unreeled completely, then distribute the cables and do not lay them on top
of each other.
Safety instructions
No more than one sack of material must be placed on the machine's safety guard.
Only remove the safety guard and mixing pipe after disconnecting the machine from the mains.
Run all hoses and cables so as to rule out stumbling hazards to the extent possible.
Place the machine on a flat and firm surface.
The machine does not have a suspension device for crane transport!
Cleaning the flow mixer
Empty the machine's storage tank when you finish work.
Use the red Off button to switch the machine off and isolate it from the mains.
Disconnect the water connection.
Remove and clean the mixing pipe and the mixing shaft.
Clean the storage tank and the metering unit (dry if possible).
Assemble the machine again.
Keep the shaft connections clean, dry and free from grease.
Maintenance
Basic safety information
Caution: Always disconnect the mains plug from the electric circuit before maintenance!
- The installation and use of spare parts and accessories not sourced from the device manufacturer is pro-
hibited!
- The maintenance intervals must be complied with.
- Changing operating parameters and components is prohibited.
Maintenance schedule
- Check the external integrity of live components before each use.
- Immediate cleaning after work use.
- Annual inspection of equipment safety in accordance with DGUV V3 by a qualified person (electrician).
Frost-proofing
Opening the dosing valve and the shut-off valve drains the water from the fittings.
47 Translation of the original instruction