Assembling Procedure - Optika Italy B-380 Serie Manuel D'utilisation

7.1

Assembling procedure

1. Insert the optical head above the stand and
tighten the screw. (Fig. 1)
• Hold the head with one hand during the
locking in order to avoid that the head falls.
2. Insert both eyepieces into the tubes of the optical
head. (Fig. 2)
3. Screw each objective into the thread of
the nosepiece,
magnification. (Fig. 3)
4. Insert the power supply jack in the connector
placed at the rear side of the microscope. (Fig. 4)
clockwise with increasing
Page 7
Fig. 1
Fig. 2
Fig. 3
Fig. 4