Setting the time/date
You can set the date and time manually or using the software.
1. Push button 1 (6) on the fitness band once. The current time setting will appear on
the LED display.
2. Push and hold button 1 (6) and button 2 (7) until the minutes are hidden and only the
hours are shown on the display.
3. Use buttons 1 (6) and 2 (7) to set the hours.
4. Hold buttons 1 (6) and 2 (7) down again until the hours are hidden and the minutes
appear.
5. Use buttons 1 (6) and 2 (7) to set the minutes.
6. Then hold down buttons 1 and 2 (7) again until the hours and minutes are hidden
and the day appears in date mode.
7. Use buttons 1 (6) and 2 (7) to set the month for the date display.
8. Then hold down buttons 1 (6) and 2 (7) again until the month is hidden in date mode
and the day appears.
9. Use buttons 1 (6) and 2 (7) to set the day for the date display.
10. The display will automatically go dark after a few seconds.
Step counter/timer
1. Hold button 2 (7) down to switch to the step counter menu. The number of steps
covered will appear on the display.
2. Push button 1 (6) once to stop the step counter and push it again to resume the step
counter.
•
Options in the step counter menu:
1. Push button 2 (7) to access the timer menu. Your workout time will be shown. You
can stop the timer and resume by pushing button 1 (6).
2. If you would like to reset the data to zero, hold down button 2 (7) in the timer
menu or in the step counter menu.
Temperature display
1. Tap button 2 once (7). The detected ambient temperature will appear on the display.
2. The display automatically deactivates after a certain time interval.
Cleaning and storage
ATTENTION!
■
Never submerge the product in water or other liquids.
■
Do not use scouring or abrasive cleaners or cleaning pads for cleaning.
•
Clean the product with a damp, soft cloth.
•
When not in use, store the product in a clean, dry area not exposed to direct sunlight,
which is not accessible to children and animals.
15
EN