Dual-Flame Stacked Burners; After Cleaning - GE Monogram ZGP364LDNSS Manuel Du Propriétaire

Masquer les pouces Voir aussi pour Monogram ZGP364LDNSS:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Dual-flame
stacked
burners
34
The burner consists of three parts: the burner
base, burner head, and burner cap. The
burner head and burner cap can be lifted off,
making them easy to clean.
CAUTION
DO NOT OPERATE THE
BURNER WITHOUT ALL BURNER PARTS
IN PLACE.
Surface burners should be cleaned routinely,
especially after bad spillovers, which could
clog the slots and holes in the burner heads.
The electrode is located at the rear of each
burner. Do not attempt to disassemble or
clean around any burner while another burner
is on. An electric shock may result.
Electrode
To remove the burner parts:
1. Turn all controls OFF before removing any
burner parts.
2. When cool, you may lift off the burner grates,
burner caps and burner heads for easier
cleaning. Do not remove the burner bases.
NOTE:
size burners. Be sure to replace the burners in
the same location.
Care and Cleaning
Cleaning
Lift off burner parts only when cool. Wash in hot,
soapy water. You may use a plastic scouring
pad to remove burned-on food particles.
To remove burned-on food, soak the burner
heads in a solution of mild liquid detergent and
hot water for 20–30 minutes. For more stubborn
stains, use a plastic scouring pad or toothbrush.
If the spill goes inside the burner head
assembly, wash it under running water and
shake to remove excess water.

After Cleaning

Before replacing the burner parts, shake out
excess water and then dry them thoroughly.
To replace the burner parts:
Burner Cap
Make sure that the burner parts are replaced
in the correct location.
1. Replace the burner head on top of the
Burner
burner base, making sure that the hole in
Head
the burner head is properly aligned with the
electrode in the burner base. A small gap
between the base and head is normal.
Burner
2. Place the burner cap on top of the burner
Base
head. Make sure that the burner cap is
properly seated on the burner head.
Professional All-Gas Range
Burner cap properly seated
Burner cap not properly seated
49-85246-1

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Monogram zgp366lnss

Table des Matières