Troubleshooting - Triple S SSS Bearcat 20TD Instructions D'utilisation

TROUBLESHOOTING

Trouble
The motors do not work; no warning light turns on.
The machine does not move
The battery Leds (61) flash simultaneously.
The pad do not work, the red warning light (61c)
is on.
The recovery water vacuuming is insufficient.
The solution flow to the pad is insufficient.
The squeegee leaves marks on the floor.
NOTE
If the machine has a battery charger installed, the machine cannot operate if the charger is not on board. In case of
battery charger malfunction, contact an authorised Service Center.
For further information refer to the Service Manual, available at any TRIPLE S Service Center.
05/2015
INSTRUCTIONS FOR USE
Possible Cause
The battery connector is disconnected.
The batteries are completely discharged.
The machine has been turned on by using
the ignition key and by keeping the switches
pressed.
The pad deck motor is overloaded.
Discharged batteries
The recovery tank is full.
The hose is disconnected from the squeegee. Connect.
The vacuum grid is clogged or the float is
stuck closed.
The squeegee is dirty or the squeegee blades
are worn or damaged.
The tank cover is not properly closed or the
gasket is damaged.
The solution filter is dirty.
The tank is dirty (the drain hole is clogged).
There are debris under the squeegee blades.
The squeegee blades are worn, chipped or
torn.
The squeegee has not been adjusted with the
handwheel.
9100001264 - SSS Bearcat 20TD
Remedy
Connect.
Charge the batteries.
Turn the ignition key to "0", then try to start the
machine again without pressing the switches.
Use a less aggressive pad suitable for the
floor to be cleaned or avoid working with extra
pressure function turned on.
Charge the batteries.
Empty the tank.
Clean the grid or check the float.
Clean and check the squeegee.
Close the cover or clean/replace the gasket.
Clean the filter.
Clean.
Remove the debris.
Replace the blades.
Adjust it.
ENGLISH
21