NOTE
For correct scrubbing/drying of floors at the sides of the walls, TRIPLE S suggests to go near the walls with the right side
of the machine as shown in figure 2.
CAUTION!
To avoid any damage to the floor surface, turn off the pad when the machine stops in one place, especially when
the extra pressure function is on.
Working with pad extra pressure function turned on
If the floor proves to be particularly difficult to clean, it is possible to turn on the pad extra pressure function by pressing the pedal
(11) to position (11c).
CAUTION!
In case of pad motor overload, due to foreign bodies which prevent them from turning, or to excessively
aggressive floors/pad, the safety system stops the pad after about one minute of continuous overload.
The overload is shown by the three warning lights (61a, 61b, 61c) flashing simultaneously.
If the overload takes place when the extra pressure function (11c) is on, the pedal position must be changed to
(11b). If the overload persists, the pad stops.
To start scrubbing again after a pad stop due to overload, stop the machine by turning the ignition key (60) to
"0". Turn on the machine by turning the ignition key (60) to "I".
Battery discharge during operation
Until the green warning light (61a) stays on, the batteries allow the machine to work normally.
When the green warning light (61a) turns off, and the yellow warning light (61b) turns on, it is advisable to charge the batteries,
because the residual autonomy will last for a few minutes (depending on battery characteristics and work to be performed).
When the red warning light (61c) turns on, the autonomy is over. After a few seconds, the pad is automatically tuned off, while the
vacuum system and the drive system stay on, to finish drying the floor and drive the machine to the appointed recharging area.
WARNING!
Do not use the machine with discharged batteries, to avoid damaging the batteries and reducing the battery life.
05/2015
A
INSTRUCTIONS FOR USE
Figure 2
9100001264 - SSS Bearcat 20TD
B
ENGLISH
P100106A
13