Preliminary Operations - Triple S SSS Bearcat 20TD Instructions D'utilisation

ENGLISH
BATTERY CHARGING
NOTE
Charge the batteries when the yellow or red warning light (61b or 61c) turns on, or at the end of every working cycle.
CAUTION!
Keeping the batteries charged make their life last longer.
CAUTION!
When the batteries are discharged, charge them as soon as possible, as that condition makes their life shorter.
Check for battery charge at least once a week.
CAUTION!
If the machine is not equipped with on-board battery charger, choose an external battery charger suitable for the
type of batteries installed.
WARNING!
WET battery charging produces highly explosive hydrogen gas. Charge the batteries in well-ventilated areas and
away from naked flames. Do not smoke while charging the batteries.
Keep the tank assembly open while charging the batteries.
WARNING!
Pay careful attention when charging the batteries as there may be battery fluid leakages. The battery fluid is
corrosive. If it comes in contact with skin or eyes, rinse thoroughly with water and consult a physician.

Preliminary operations

1. Open the cover (22) and check that the recovery tank (21) is empty, otherwise empty it with the drain hose (16).
2. Drive the machine to the appointed recharging area.
3. Turn the ignition key (60) to "0".
4. Carefully lift the recovery tank (40).
5. For WET batteries only:
• Check the level of electrolyte inside the batteries (28); if necessary, top up through the caps (45).
• Then leave all the caps (45) open for battery charging.
• If necessary, clean the upper surface of the batteries.
6. Charge the batteries according to one of the following procedures, depending on the presence of the battery charger (70).
7. Connect the battery charger cable (6) to the electrical mains (the electrical mains voltage and frequency must be compatible
with the battery charger values shown on the machine serial number plate (34)).
When the battery charger is connected to the electrical mains, all machine functions are automatically cut off.
If the red warning light (74) on the battery charger control panel stays on, the battery charger is charging the batteries.
8. When the green warning light (72) turns on, the battery charging is completed.
9. When the battery charging is completed, disconnect the battery charger cable (6) from the electrical mains and wind it round
its housing (7).
10. Carefully lower the recovery tank (40).
NOTE
For further information about the battery charger (70) operation, see the relevant Manual.
16
INSTRUCTIONS FOR USE
SSS Bearcat 20TD - 9100001264
05/2015