Use; Battery Check/Setting On A New Machine - Triple S SSS Bearcat 20TD Instructions D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH

USE

WARNING!
On some points of the machine there are some adhesive plates indicating:
– DANGER
– WARNING
– CAUTION
– CONSULTATION
While reading this Manual, the operator must pay particular attention to the symbols shown on the plates.
Do not cover these plates for any reason and immediately replace them if damaged.

BATTERY CHECK/SETTING ON A NEW MACHINE

WARNING!
The electric components of the machine can be seriously damaged if the batteries are either improperly installed
or connected. The batteries must be installed by qualified personnel only. Set the function electronic board and
the battery charger according to the type of batteries used (WET or GEL).
Check the batteries for damage before installation.
Disconnect the battery connector and the battery charger plug.
Handle the batteries with great care.
Install the battery terminal protection caps supplied with the machine.
The machine requires two 12 V batteries, connected according to the diagram (29).
The machine can be supplied in one of the following modes:
A)
Batteries (WET or GEL) already installed and ready to be used
1. Check that the batteries are connected to the machine with the connector (12).
2. Insert the ignition key (60) and turn it to "I".
If the green warning light (61a) turns on, the batteries are ready to be used.
If the yellow or red warning light (61b or 61c) turns on, the batteries must be charged (see the procedure in Maintenance
chapter).
B)
Without batteries
1. Buy appropriate batteries (see Technical Data paragraph).
2. For battery choice and installation, apply to qualified battery Retailers.
3. Set the machine and the battery charger (if equipped) according to the type of batteries installed (WET or GEL) as shown
in the following paragraph.
10
INSTRUCTIONS FOR USE
SSS Bearcat 20TD - 9100001264
05/2015

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

86016

Table des Matières