Tank Emptying; After Using The Machine; Machine Long Inactivity; First Period Of Use - Triple S SSS Bearcat 20TD Instructions D'utilisation

ENGLISH

TANK EMPTYING

An automatic float shut-off system (36) turns off the vacuum system when the recovery tank (21) is full.
The vacuum system deactivation is signalled by a sudden increase in the vacuum system motor noise frequency, and the floor is
not dried.
CAUTION!
If the vacuum system turns off accidentally (for example, when the float is activated because of a sudden
machine movement), to resume the operation: turn off the vacuum system by pressing the vacuum switch (53),
then open the cover (22) and check that the float inside the grid (36) has gone down to the water level. Then
close the cover (22) and turn on the vacuum system by pressing the vacuum switch (53).
When the recovery tank (21) is full, empty it according to the following procedure.
Recovery tank emptying
1. Stop the machine.
2. Lift the pad deck by pressing the pedal (11).
3. Lift the squeegee (25) with the lever (10).
4. Drive the machine to the appointed disposal area.
5. Empty the recovery tank with the hose (16). Then, rinse the tank with clean water.
Solution tank emptying
6. Perform steps 1 to 4.
7. Empty the solution tank with the hose (17). Then, rinse the tank with clean water.

AFTER USING THE MACHINE

After working, before leaving the machine:
1. Remove the pad as shown in the relevant paragraph.
2. Empty the tanks (20 and 21) as shown in the relevant paragraph.
3. Perform the daily maintenance procedures (see the Maintenance chapter).
4. Store the machine in a clean and dry place, with the pad and the squeegee lifted or removed.

MACHINE LONG INACTIVITY

If the machine is not going to be used for more than 30 days, proceed as follows:
1. Perform the procedures shown in After Using the Machine paragraph.
2. Disconnect the battery connector (12).

FIRST PERIOD OF USE

After the first 8 hours, check the machine fastening and connecting parts for proper tightening and check the visible parts for
integrity and leakage.
14
INSTRUCTIONS FOR USE
SSS Bearcat 20TD - 9100001264
05/2015