Pad Cleaning; Vacuum System Motor Filter Cleaning; Solution Filter Cleaning - Triple S SSS Bearcat 20TD Instructions D'utilisation

ENGLISH

PAD CLEANING

CAUTION!
It is advisable to wear protective gloves when cleaning the pad because there may be sharp debris.
1. Remove the pad from the machine, as shown in Use chapter.
2. Clean and wash the pad with water and detergent.
3. Check the pad for integrity and wear; if necessary, replace them.

VACUUM SYSTEM MOTOR FILTER CLEANING

1. Drive the machine on a level floor.
2. Turn the ignition key (60) to "0".
3. Open the recovery water tank.
4. If necessary, drain the water from the tank in order to make the filter visible.
5. Check that the pre-filter is clean. If necessary clean it with water and compressed air, then install it.
6. Perform steps 1, 2 and 3 in the reverse order.

SOLUTION FILTER CLEANING

1. Drive the machine on a level floor.
2. Turn the ignition key (60) to "0".
3. Close the solution tap (A, Fig. 4) under the machine, behind the right rear wheel. The tap (A) is closed when it is in the position
(B) and it is open when it is in the position (C).
4. Remove the transparent cover (D), then remove the filter strainer (E). Clean and install them on the support (F).
NOTE
The filter strainer (E) must be correctly positioned on the housing (G) of the support (F).
5. Open the tap (A).
18
INSTRUCTIONS FOR USE
F
E
D
SSS Bearcat 20TD - 9100001264
C
A
B
Figure 4
G
E
P100118
05/2015