Royal Catering RCHT-1000 Manuel D'utilisation page 6

LED display with temperature:
1. buttons for setting the temperature
2. Set button
Temperature setting:
Press the „Set" button once. Set the required temperature using "˄" or "˅" buttons.
Parameters setting:
Press and hold the „Set" button for about 6 seconds to enter the parameters setting
(display will show "d"). Set the parameters LS – HS – Pt – CA – d using "˄" or "˅"
buttons:
Function Description Factory value
LS – press Lower temperature 000
and hold limit
„Set" button
and at the
same time
press "˄" or
"˅" buttons
HS – press Upper temperature 101
and hold limit
„Set" button
and at the
same time
press "˄" or
"˅" buttons
Pt – press Thermostat restart 000
and hold delay
„Set" button
and at the
same time
press "˄" or
"˅" buttons
10
Adjustment range Unit
0 – to working °C
temperature – 1°C
Working °C
temperature +1°C
do 400
0 – 3 min
Rev. 05.09.2018
CA – press Temperature 000
and hold indication
„Set" button correction.
and at the
same time
press "˄" or
"˅" buttons
d – press and Difference between 003
hold „Set" turn off thermostat
button and at temperature and
the same time restart thermostat
press "˄" or temperature.
"˅" buttons
NOTICE: all above parameters have been set by the manufacturer.
It is strongly recommended not to modify any of these parameters!
Error codes:
E1 – incorrect work of temperature sensor (temperature sensor damage).
E2 – actual temperature is higher than the upper limit of temperature.
Functioning
The temperature in the cabin is measured in regular intervals. This information is
transmitted to the thermostat as a current value, and gets compared to the value set
by the user.
• If the current value is lower than the set value, the thermostat makes the device
heat.
• If the current value is higher than or equal to the set value, the thermostat stops
heating.
Regardless of this cycle, the digital display shows the ambient temperature in the cabin,
so that the user can compare it to the set value and adjust it more precisely in an easy
way.
OPERATION
1. Plug in the device and turn it on using the ON/OFF switch, the display will turn on.
2. Regulate the thermostat on the chosen value:
a) First press the „Set" button on temperature display one time.
b) Press the "˄" or "˅" button to select your required temperature. After 1 to
3 seconds the display will revert back to actual temperature.
c) The orange light will come on when the element is heating. This will switch on
and off automatically during the heating process.
Rev. 05.09.2018
-15 ~ +15 °C
1 – 15 °C
11