Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8558769
WARNING: Use only those fasteners recommended for use with this tool. Fasteners not
identified for use with this tool by the tool manufacturer are able to result in a risk of injury
to persons or tool damage when used in this tool.
WARNING: Keep the tool pointed away from yourself and others when loading fasteners.
Failure to do so could result in possible serious personal injury.
WARNING: Never load fasteners with the workpiece contact or trigger activated. Doing so
could result in possible serious personal injury.
UNLoADING FASTENERS
Unloading is the reverse of loading. Always disconnect the air resource before unloading.
WARNING: Always unload all fasteners before removing tool from service.
WARNING: Always disconnect the air resource before unloading.
CLEARING JAMS
Occasionally, a fastener may become jammed in the firing
mechanism of the tool, making the tool inoperable. To
remove a jammed fastener, follow the steps below:
1.
Disconnect the tool from air source.
2.
Remove fasteners from the tool. Failure to do so
will cause the fasteners to eject from the front of
the tool.
3.
Completely remove the small nose screws (D)
and the top nose plate (E) to reveal the
jammed fastener.
4.
Using caution not to bend or damage the driver blade, using pliers or a screwdriver if
required to clear the jammed fastener.
5.
Put the nose plate (E) back on the nose (F), fastening it with the screws (D).
6.
Reconnect the tool to the air source.
7.
Reload the tool with fasteners.
WARNING: Make sure there is no fastener in magazine before clearing a jam.
WARNING: Disconnect the tool from the air source whenever clearing a jam. After
disconnecting the tool from the air compressor, there should still be enough air pressure
to fire the tool. After the air hose is disconnected, always fire the tool into scrap wood
repeatedly to make sure all of the compressed air is expended.
NoN-MARRING PAD
The non-marring pad attached the nose of the tool helps prevent marring and denting when
working with softer woods.
WARNING: Disconnect the tool from the air source before removing or replacing the no-
marring pad. Failure to do so could result in serious personal injury.
Visit www.princessauto.com for more information
Fine Wire Stapler
V 4.0
9
Publicité
Table des Matières
