Lubrication; Cold Weather Operation - Power Fist 8558769 Manuel D'utilisation

8558769
MAINTENANCE
WARNING: Any time inspection, maintenance, and cleaning are done:
•
Disconnect the tool from the air resource.
• Empty the magazine completely.
ANTI-DUST
Each tool is packed with an anti-dust cap on the air connector, check it after unpacking.
Keep the anti-dust cap cover the air connector when the tool is not in use.

LUBRICATIoN

Frequent, but not excessive, lubrication is required for best performance after long periods of
use. Oil for pneumatic fastening tools is added through the air line connection and will lubricate
internal parts. Do not use detergent oil or additives. These lubricants will cause accelerated
wear to the seals and bumpers in the tool, resulting in poor tool performance and frequent
tool maintenance.
CAUTION: Lubricate tool only with specified lubricants.
CLEANING
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from
various types of commercial solvents and maybe damaged by their use. Use clean cloths to
remove dirt, dust, oil, grease, etc.
WARNING: Do not at any time let brake fluids, gasoline, petroleum-based products,
penetration oils, etc., come in contact with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal injury.

CoLD WEATHER oPERATIoN

For cold weather operation, near and below freezing, the moisture in the air line may freeze and
prevent tool operation. We recommend the use of air tool lubricant or permanent antifreeze
(ethylene glycol) as a cold weather lubricant.
CAUTION: Do not store tools in a cold weather environment to prevent frost or ice formation
on the tool's operating valves and mechanisms that could cause tool failure.
Visit www.princessauto.com for more information
Fine Wire Stapler V 4.0
11