Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V 4.0
15. Do not touch the trigger unless driving fasteners. Never attach air line to tool or
carry tool while touching the trigger. The tool could eject a fastener which will result
in death or serious personal injury. Also actuate the trigger lock to the safe position
when not in use.
16. Always fit tool with a fitting or hose coupling on or near the tool in such a manner that
all compressed air in the tool is discharged at the time the fitting or hose coupling is
disconnected. Do not use a check valve or any other fitting which allows air to remain
in the tool. Death or serious personal injury could occur.
17. Never place hands or any other body parts in the fastener discharge area of the tool.
The tool might eject a fastener and could result in death or serious personal injury.
18. Never carry the tool by the air hose or pull the hose to move the tool or a compressor.
Keep hoses away from heat, oil and sharp edges. Replace any hose that is damaged,
weak or worn. Personal injury or tool damage could occur.
19. Always assume the tool contains fasteners. Respect the tool as a working implement;
no horseplay.
20. Always keep others at a safe distance from the work area in case of accidental
discharge of fasteners. Do not point the tool toward yourself or anyone whether it
contains fasteners or not. Accidental triggering of the tool could result in death or
serious personal injury.
21. Do not drop or throw the tool. Dropping or throwing the tool can result in damage
that will make the tool unusable or unsafe. If the tool has been dropped or thrown,
examine the tool closely for bent, cracked or broken parts and air leaks. STOP and
repair before using, or serious injury could occur.
22. Avoid using the tool when the magazine is empty. Accelerated wear on the tool
may occur.
23. Clean and check all air supply hoses and fittings before connecting the tool to an
air supply. Replace any damaged or worn hoses or fittings. Tool performance or
durability may be reduced.
24. Do not use the tool if it leaks air or does not function properly.
25. Do not operate the tool if it does not contain a legible warning label.
26. Always carry the tool by the handle. Never carry the tool by the air hose.
TooL SERVICE
1.
Use only accessories that are identified by the manufacturer for the specific
tool model.
2.
Use of unauthorized parts or failure to follow maintenance instructions may create
a risk of injury.
3.
Use only the lubricants supplied with the tool or specified by the manufacturer.
4.
Tool service must be performed only by qualified repair personnel.
oPERATIoN
1.
Do not drive fasteners near edge of material. The workpiece may split causing the
fastener or ricochet, injuring you or people around.
2.
Do not carry the tool from place to place holding the trigger. Accidental discharge
could result. Choice of triggering method is important. Check manual for
triggering options.
6
Fine Wire Stapler
For technical questions call 1-800-665-8685
8558769
Publicité
Table des Matières
