Publicité
Les langues disponibles
Les langues disponibles
26. Apply UHU-por to the undercarriage locating slots in the wing (this is a wet joint - don't allow the adhesive
to dry out). Use plenty of glue - too much does no harm here. Now slide the undercarriage legs through the
undercarriage slot in the bottom fuselage section and into the undercarriage locating slots. Glue the
undercarriage legs in the undercarriage slots using plenty of UHU-por, and allow the glued joints to dry out
for at least one hour (preferably overnight - the longer the better). Don't touch or stress the undercarriage
while the glue is setting.
27. The wheel axles (35) can now be glued in the wheel axle supports: apply a small drop of high-viscosity
(thick) cyano to the wheel axle support, then push the wheel axle into the unit, ensuring that the axle is
positioned parallel to the ground.
28. Glue the wheel spat mounts (36) to the wheel spats (37) using UHU-por. Take care to make a mirror-
image pair (different left and right).
29. Slip the main wheel (38) onto the wheel axle, then fit the wheel spat and mount onto the wheel axle to a
depth of about 1 mm. Apply a drop of thick cyano to the hole in the axle support, and push the spat fully
onto the axle. Repeat with the second wheel.
30. Mount the variable-pitch propeller on the motor shaft.
Setting up the model
Control surface travels (for the first few flights it is sensible to limit the control surface travels to about 60%
•
of the values stated below. Do this using Dual Rates, and assign D/R switches if required):
Elevator 50 mm up, 50 mm down
Rudder
50 mm right, 50 mm left
Aileron
45 mm up, 45 mm down
Centre of Gravity position: about 75 mm from the wing root leading edge.
•
First flight: charge the batteries and check all the model's working systems. Carry out a range check. Wait
•
for a day with as little breeze as possible (flat calm is ideal). Now you are ready for the model's first flight.
Ask an experienced launcher to give the Extra a gentle hand-launch. The motor has plenty of power, and
the model does not need a powerful launch. Adjust the trims if necessary, and take your time to get to know
the aeroplane's handling characteristics before trying out aerobatics for the first time.
The following items are also required (not included in the kit)
1 x COMPACT 160 7.4 V
4 x C 1041 servo
1 x XP 10 FM 35 MHz receiver
1 x 3 LiPo 400 flight battery, 11.1 V / 0.40 Ah
Optional accessories and tools (not included in the kit)
1 x Styrofoam cyano-acrylate glue ("foam cyano")
1 x UHU POR adhesive
1 x Cyano-acrylate activator spray
1 x Sanding block
1 x Self-adhesive glass fibre tape
Radio control system
1 x mc-12 35 MHz radio control set
Other Graupner/JR 35 MHz FM radio control systems are also suitable.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Keine Haftung für Druckfehler. Technische Änderungen vorbehalten!
Order No. 7737
Order No. 5116.LOSE
Order No. 7020
Order No. 7606.3
Order No. 5820
Order No. 959
Order No. 953.150
Order No. 1067
Order No. 98709
Order No. 4724
31
ID# 0058880
01/2008
Publicité
