Electromagnetic Compatibility Information - HoMedics BPW-1005-EU Manuel D'instructions

ELECTROMAGNETIC COMPATIBILITY INFORMATION

Table 1 For all ME EQUIPMENT and ME SYSTEMS
Guidance and manufacture's declaration – electromagnetic emission
The [BPW-1005] is intended for use in the electromagnetic environment specified below.
The customer or the user of the [BPW-1005] should assure that it is used in such an environment.
Emission test Compliance
RF emissions
Group 1
CISPR 11
RF emission
Class B
CISPR 11
Harmonic
emissions Not applicable
IEC 61000-3-2
Voltage
fluctuations/
flicker Not applicable
emissions
IEC 61000-3-3
Table 2 For all ME EQUIPMENT and ME SYSTEMS
Guidance and manufacturer's declaration - electromagnetic immunity
The [BPW-1005] is intended for use in the electromagnetic environment specified below.
The customer or the user of the [BPW-1005] should assure that it is used in such an environment.
IEC 60601
Immunity test
test level
Electrostatic ±6 kV contact
discharge (ESD) ±8 kV air
IEC 61000-4-2
Power frequency 3A/m
(50/60 Hz)
magnetic field
IEC 61000-4-8
Electromagnetic environment - guidance
The [BPW-1005] uses RF energy only for its internal function.
Therefore, its RF emissions are very low and are not likely to
cause any interference in nearby electronic equipment.
The [BPW-1005] is suitable for use in all establishments
other than domestic and those directly connected to the
public low-voltage power supply network that supplies
buildings used for domestic purposes.
Compliance
level
±6 kV contact Floors should be wood, concrete or ceramic tile.
±8 kV air If floors are covered with synthetic material, the
relative humidity should be at least 30%.
3A/m Power frequency magnetic fields should be at
levels characteristic of a typical location in a
typical commercial or hospital environment.
14 14
Electromagnetic
environment - guidance
Table 3
The [
The c
Immu
Radia
IEC 61
NOTE
NOTE
Fiel
a
and
pre
tran
the
[BP
add
Ove
b