Dawicontrol DC-29160 U3W Mode D'emploi page 31

Manual
I. Introduction
1. Preface
2. Description of the DC-29160 U3W
3. Controller Features
4. Special SCSI Interface Features
4.1. Connecting SCSI Devices
4.2. SCSI Bus Termination
4.3. SCSI Bus Connections
5. The Dawicontrol SCSI Software Concept
5.1. Synchronous and Asynchronous Data Transmission
5.2. Parity Check / CRC Check
5.3. SCSI Drive Power Management
5.4. BIOS Installation of Hard Drives
5.5. Booting from CD
II. Installation
1. Reviewing Defaults
2. Installation
3. BIOS Update
4. SCSI Setup
III. Installation under DOS / Windows 3.1
1. Driver Based SCSI Drive Installation
1.1. Summary of DC29160.SYS Command Line Switches
1.2. Typical Structure of the CONFIG.SYS File
2. Driver Based Disk Drive Installation
2.1. Summary of DISKDRV.SYS Command Line Switches
3. SCSIFMT Disk Drive Preparation
3.1. "Edit Partition Table", Creating and Deleting Partitions
3.2. "BIOS Translation Mode", Modifying Drive Parameters
3.3. "Low Level Format", Basic Formatting
3.4. Summary of SCSIFMT Command Line Switches
4. Installing CD-ROM Drives
4.1. Summary of CDROM.SYS Command Line Switches
5. Installing Further SCSI Devices
- 31 -
33
33
33
34
34
34
35
36
36
37
37
38
38
39
39
40
40
42
42
43
43
44
45
47
47
48
49
49
50
51