Panasonic WX-ST400P Mode D'emploi page 36

Troubleshooting
Phenomenon
The [PWR] indicator
blinks green and I
cannot use the
microphone
Audio from the
microphone unit is not
transmitted
I cannot charge the
microphone
(The [CHG] indicator
stays off)
I cannot charge the
microphone
(The [CHG] indicator
only stays on for a few
minutes)
36
Cause/measure
⚫ You cannot use the microphone because there
is another active microphone paired to the
same channel.
 Stop using the other microphone paired to 
the same channel.
⚫ The microphone may be almost outside of the
antenna range.
 Move the microphone inside the antenna 
range.
⚫ Is an external device connected to the [AUDIO
IN] connector?
 When an external device is connected, even 
if it is turned OFF, it will take precedence
over the microphone unit, which will stop
audio transmission from the microphone unit.
Disconnect the plug from the [AUDIO IN]
connector.
⚫ Is the volume on the receiver, connected
amplifier, etc. high enough?
 Adjust the volume with the volume 
adjustment knob.
⚫ Is the microphone properly inserted into the
charger?
 Make sure that the microphone is properly 
inserted into the charger.
⚫ Is the battery already charged?
 The battery may already be fully charged. 
Take the microphone out of the charger and
use it as normal.
Reference
page
13
13
29
―
32
32