Using The Microphone - Panasonic WX-ST400P Mode D'emploi

Using the microphone

1
Make sure that the receiver is turned ON
Make sure that the [POWER] indicator on the wireless receiver lights green.
Power indicator
2
Press the power switch on the microphone to turn it ON.
The [PWR] indicator on the microphone lights up.
When the microphone is turned ON, the audio
collected by the microphone unit is transmitted.
⚫ If the [PWR] indicator on the microphone blinks red, the microphone is
not paired to a wireless receiver. Perform the steps described in
"Pairing" (page 20).
⚫ After use, return the power switch on the microphone to the OFF position.
Press the power switch once more to turn the microphone OFF. The [PWR] indicator
goes off.
⚫ Do not place the microphone near the speakers. Doing so may cause
howling and other loud noises which may cause injuries to the ears.
Important
⚫ If the microphone moves out of the antenna range, the [PWR] indicator
blinks orange and the microphone stops audio transmission. Move the
microphone back into the antenna range to resume transmission. Refer to
the wireless receiver manual for specifics on the wireless transmission
range.
⚫ Keep a distance of at least 50 cm (19-5/8 inch) between this microphone
and other wireless microphones. Placing multiple microphones within 50 cm
(19-5/8 inch) of each other may cause transmission lag, audio dropouts, and
noise.
28
Power indicator
Power switch