Panasonic WX-ST400P Mode D'emploi page 14

Parts and their names
⚫ The indication of the remaining battery level will change according to the
battery type (either alkaline dry-cell or Ni-MH) selected through the
microphone battery setting switch on the wireless receiver.
⚫ Setting the battery type switch to the wrong position will not interfere with the
operation of the microphone, but it may result in the orange and red
indicators lighting up for too long or too short, displaying an incorrect reading
of the remaining battery level.
⚫ The microphone battery type setting on the wireless receiver applies to all
microphones paired with it, and cannot be changed individually.
Refer to the wireless receiver manual for further details.
④ Power switch
Turns the microphone ON/OFF.
Pressing the power switch will turn the microphone ON, and audio from the microphone
unit will be transmitted.
Pressing the power switch again while the microphone is ON will turn the microphone
OFF.
⑤ Microphone unit
Collects audio.
A windscreen is attached to the microphone unit.
⚫ The windscreen is an expendable component which deteriorates with use. Refer to a
retailer for replacement.
⑥ External input connector [AUDIO IN]
Transmits the audio from the external device to the receiver (page 29).
When an external device is connected to this connector, audio from the microphone unit
will not be transmitted to the receiver.
⑦ Hook
The attachment hook for the microphone. Used to attach the microphone to a belt or
breast pocket.
⑧ Space to place stickers for microphone identification
Place the included microphone identification stickers here. Using the stickers makes it
easier to identify microphones.
⑨ Battery cover
Slide the battery cover downwards while pressing on it to remove it.
⑩ Sensitivity setting switch [SENS L/H] (inside the battery cover)
Sets the sensitivity to audio from for the microphone unit (page 19).
[SENS L] : Low sensitivity (factory default)
[SENS H] : High sensitivity
14