No. 821 Blade Cutter And No. 822 Adapter Kit; Cut Grooving, Beveling And Cut-Off With No. 821 Blade Cutter (45 Rpm); Left Hand Machine Operation; Positioning Front Jaws For Left Hand Operation - RIDGID 1822-I Mode D'emploi

1822-I Pipe and Bolt Threading Machine
Oil Manifold/Lever
(Hidden)
(Set Screws)
Pinion Sleeve
Figure 20 – Operation of the No. 141 Geared Threader
No. 821 Blade Cutter and
No. 822 Adapter Kit
No. 821 Blade Cutter allows the machine to groove,
bevel and produce square end cuts for lined pipe and
other applications. Installation requires a No. 822 Adapter
Kit. The kits includes a cutter attaching arm, oil supply
manifold and manifold clamp/drip tray. Reference in-
structions with kit.
Installation of No. 821 Blade Cutter
1. Remove standard No. 364 Wheel Cutter from car-
riage.
2. Install attaching arm and No. 821 Blade Cutter.
3. Disconnect plastic oil supply line and metal fitting
from carriage.
4. Attach metal manifold supply line to carriage, install
manifold and manifold clamp/drip tray.
5. Reattach plastic oil supply line to manifold.
Cut Grooving, Beveling and Cut-Off with
No. 821 Blade Cutter (45 RPM)
1. Install tool bit required for desired operation.
2. Chuck pipe and place oil supply lever in the position
required to direct cutting oil to flexible oil spout.
3. Place cutter over pipe and with machine in operation,
tighten cutter handle until rolls engage pipe.
4. Direct oil spout to the cutting surface and slowly turn
tool feed handle.
Oil Spout
Connecting
Link
Drive Shaft
Ridge Tool Company
Guide Post
Workholder
Clamp Screw
Carriage
Saddle
Handwheel

Left Hand Machine Operation

Machine is capable of left hand operation. However,
user or Authorized Service Center modification is re-
quired. Basically, front and rear jaws are inverted and oil
lines are exchanged. In addition, a left hand die head
must be pinned to the near side of the carriage through
the hole in carriage rest.
NOTE! Left hand reaming requires an E-863 Reamer
Cone.
Both front and rear jaws must be in left hand
CAUTION
mode as shown in Figure 21.
Positioning Front Jaws
for Left Hand Operation
(Figure 21)
1. Run machine in the OPEN position to open jaws.
WARNING Make sure machine is unplugged from
power source before performing maintenance or making
any adjustments.
2. With machine OFF and unplugged, remove front
and rear covers.
3. Manually rotate front jaws toward CLOSE position and
remove three E-Clips holding front retainer in place.
Remove retainer and spacers.
4. Remove E-Clips and washers holding front jaws on
drive pins and remove front jaws.
5. Reverse front jaws and install on drive pins and rods.
Pipe
VJ-99 Pipe
Stand
17