Electrical Requirements - Bosch 700 Serie Notice D'installation

1. Be sure to read the above WARNING before at-
tempting to remove oven door.
2. Open the door all the way.
3. Flip levers on hinges (one on each side)
toward you.
4. Close the door until it stops. It will be about
halfway open.
5. Holding the door firmly on both sides and using
both hands, pull the door straight out of the hinge
slots. Hold firmly, the door is heavy.
6. Place the door in a stable location.

electrical requirements

Refer to data plate for more information. See "Prod-
uct Data Plate" on page 16 for data plate location.
We recommend that the range be installed with a
power cord set (not supplied). The electrical rating
of the power cord set must be 120/240 volt, 30 am-
peres minimum. The power cord set shall be marked
"For Use with Ranges." Always use a new power
cord.
note: In Canada, the range is shipped from the fac-
tory with the range cord already installed.
Ranges are dual rated for use on either 120/240 VAC
or 120/208 VAC. Check the data plate for the kW
rating. Reference the kW rating in the table below to
determine amperage requirements.
electrical specifications
Volts a.c. hZ rating KW circuit breaKer
120/240 60
120/208 60
The electrical outlet must be located in the shaded
space shown on the figure in the next column.
6.2 30 AMPS
4.8 30 AMPS
Verify that wiring to house is adequate
Contact your local utility company to verify that the
present electric service to your home is adequate. In
some instances, the size of the wiring to the house
and service switch must be increased to handle the
electrical load demanded by the range.
Most wiring codes require a separate circuit with
separate disconnect switch and fuses either in the
main entrance panel or in a separate switch and fuse
box.
The range requires a minimum of a three wire
120/240 or 120/208 volt, 30 AMP, 60 Hz AC circuit.
Check local codes for proper amperage ratings. A
four wire connection is preferred.
Most local building regulations and codes require
that electrical wiring be done by licensed electri-
cians. Be sure to install your range according to the
electric codes in place in your region.
gas requirements
,
cautIon
Make certain that gas shutoff valve and all burner con-
trols are in the oFF position before beginning.
Shut off main gas supply valve before disconnecting
the old range and leave it off until the new hook-up
has been completed. Don't forget to relight the pi-
lot on other gas appliances when you turn the gas
back on.
7 1/2"
(190.5 mm)
4 1/2"
114.3 mm
13 1/8 "
(333 mm)
If not already present, install gas shut off valve in an
easily accessible location.
Make sure all users know where and how to shut off
the gas supply to the range.
note: The installer should inform the consumer of
the location of the gas shutoff valve.
Important note for lP users
The range is shipped from the factory for use with
natural gas. For use with propane (LP) gas, your
range must first be converted using the LP conver-
sion kit.
3 1/2"
88.9 mm
4"
(101.6 mm)
3 7/8"
(98 mm)
30"
(762 mm)
4 1/2"
114.3 mm
7