Procedure; Installation Of Anti-Tip Bracket; Apply Foam Tape; Install Backwall Trim (Optional) - Bosch 700 Serie Notice D'installation

Procedure

Installation of anti-tip bracket

1. Adjust height of range and level by rotating the ad-
justable leg supports on the bottom of the range,
using 1-1/4" (32 mm) wrench.
2. Locate bracket position as shown below.
3. Secure bracket with 2 screws to the floor or to
the wall. Depending on floor or wall material use
wood or anchorless concrete screws (included).
Concrete screws require a 3/16" masonry bit.
Screws should provide firm attachment into solid
wood or flooring. Do not attempt to anchor into
drywall.

apply Foam tape

Apply foam tape to underside of cooktop trim in one
continuous piece.

Install backwall trim (optional)

note: This step is only required if the countertop
does not connect behind the range (i.e.; when
replacing a free-standing range). If backwall trim
and attachment screws are required, they may
be ordered from the service center by calling
800-944-2904 at no charge for up to one year
after purchase date of your Slide-In Range.
When ordering, refer to Service
Backwall Trim Kit part no. 652010.
Install 2 screws through holes in trim and in range
backwall.
Install Backwall Trim Strip
Backwall
Trim Strip

connect electric

There are two possible electrical connections:
1. Four wire range cord
2. Three wire range cord
The four wire range cord connection is the recom-
mended method, but where local codes permit,
three wire connections are also acceptable.
note: In Canada, the range is shipped from the fac-
tory with the range cord already installed.
For installations other than those in Canada, connect
the range cord at the terminal block (See next page
for detailed instructions). Access the terminal block
by removing the cover in the lower right hand corner
of the range back panel.
Back of Range
9