Videotec DCK Manuel D'instructions page 68

5.2.4.1 Defining the v iews
Views are set up by pressing three keys simultaneously, from
operator is authorised to set up the views.
The display shows the current setup of the view for about one second, and then passes to the request for new
parameters:










5.2.4.2 Requesting th e views

Press a key from
5.2.4.3 Erasing the c ustomised views

Press keys
The default settings for the views can be used to recall cameras 1 to 9 directly without changing the active
monitor and without making scans. The
The display in the example illustrated here shows that when key
1 is pressed, this is a request for camera 1 on the active monitor
(the
the operation).
Inserting the camera.
Insert a number or press
number.
Inserting the monitor.
Insert a number or press
number. If the number 0 is inserted this means the active monitor
will not be changed when the view is requested.

to to request the corresponding view.
simultaneously.


symbol means that no monitor in particular is requested for

recalls camera 10.
Page 18

to

to confirm the previously defined

to confirm the previously defined
, if the
MNVCDCK_0441