Lan Connection - Resol VBus/Modbus Manuel

Carry out the connection of the device  to the controller / other mod-
ules in the order described below:
Î Connect the data cable (VBus , ) to a controller . If necessary, extend the
®
cable using the terminal block included and a 2-wire cable (bell wire).


Î Connect VBus ® accessory  via the data cable, if necessary.
If a further VBus cable is to be connected, proceed as follows:
®
Î In order to open the housing, unscrew the screw and remove the upper part
of the housing.
Î Connect the 2-wire cable (bell wire) to the 2 VBus
any polarity.
Î Close the housing.


Î Connect the device to the mains by means of the mains adapter .
Î For a direct connection to a router, connect the device to a router  using the
network cable (included with the device, ).

® terminals (A) and (B) with
(A) (B) (C) (D)
Connection terminals of the interface adapter
www


3.3

LAN connection

The device can be connected to a router by using a network cable (CAT5e, RJ45
or similar).
Î Connect the network cable included to the LAN connector of the router and
to the LAN connector of the device.
For the next step of commissioning, see chap. 5 on page 23.
The LAN connector is located on the front side of the device and supports trans-
fer rates of up to 100 MBit per second.


21