Electrical Connection - Resol VBus/LAN Mode D'emploi

Upper part of
the housing
Cover screw
Front view
Molds for the
rubber pads
Base part of
the housing
Back view
18

Electrical connection

ATTENTION
ATTENTION
Opening for
the mounting
screw
The VBus
and a LAN connection to function. To install the VBus
the housing has to be opened.
Hanging
Î To open the housing, unscrew the cover screw and pull
off the upper part of the housing
Î Connect the included VBus
nals with either polarity
The VBus
wire cable (bell wire). The cross section of the cable must
be at least 0.5 mm
50 m in the case that one module is used.
! ESD damage!
Electrostatic discharge can lead to damage
to electronic components!
Î Take care to discharge properly before
touching the inside of the device!
! Short circuit!
A short circuit can lead to damage to elec-
tronic components!
Î Finish terminal connection and close
the housing before establishing the
mains connection!
/LAN interface adapter needs a mains, a VBus
®
® cable to the VBus
cable can be extended or replaced with a two-
®
and the cable can be extended up to
2
®
cable,
®
® termi-