Preliminary Check; Hot Water - Sanremo Milano XLC SAP Livret D'instructions

ENGLISH
Before using the appliance, check that:
- the plug is inserted properly into the mains power outlet;
- the fi lling hose is correctly connected to the mains outlet and that the water supply is open. Also
check for leaks;
- the drain hose is positioned according to the above instructions and fi xed by a hose clamp.
With the steam tap (B) open, put the on/off switch (D) to position 1 and wait for the water in the boiler
to reach the maximum level set by the electronic control, which can be visually checked on the
Check through the water level indicator (L) that there is suffi cient water in the boiler before dispensing
hot water or steam.
Ensure that the boiler pressure gauge indicates a pressure of 0.5:1 bar.
Press the button (M6) to dispense hot water and press again to stop.
Pay the utmost attention in order to prevent scald burns.
Except for the 1-group machine that has just one steam nozzle, all the other models have 2 located
at the sides. These steam nozzles are recessed but can swivel out thanks to an articulated joint. To
dispense steam, just turn the knobs (B) counter-clockwise.
Pay the utmost attention in order to prevent scald burns.
Insert the fi lter holder (E) into the group head (F) turning the fi lter holder counter-clockwise. Press
the button (I) and wait for the required quantity of coffee to be dispensed, then put it back to its
original position.
Insert the fi lter holder (E) into the group head (F) turning the fi lter holder counter-clockwise. Using
the keypad (M) select the caption corresponding to the required type of coffee:
M1=One strong/normal coffee.
M2=One normal/weak coffee.
M3=Two strong/normal coffees.
M4=Two normal/weak coffees.
M5=Key for electronic programming or continual manual dispensing.

Preliminary check

level indicator (L). If the boiler does not fi ll within the set time-out (90 sec.),
the pump stops and the indicator lights on the control panel start to blink.
If this happens, put the on/off switch (D) to position 0 and then to position 1
per to complete fi lling of the boiler.
Than put the on/off switch (D) to position 2, which switches on the electric
heating elements to start heating the water.
Wait for steam to come out the steam nozzle (B), then close the tap and,
using the Boiler pressure gauge, check that the pressure has reached and
maintains a value of 0.8:1 bar. If not, use a screwdriver to turn the pressure
switch adjustment screw towards + or - as shown below.

Hot water

Coffee with Mod. MILANO XLC SAP
Coffee with Mod. MILANO XLC SED
USE
Steam
28